HEAVY DUTY DISC MOWERS

HAY: IT’S IN OUR DNA.

New Holland H6000 Series heavy-duty disc mowers breeze through the toughest conditions to give you a clean, even cut in less time. Discs spin up to 3,000 rpm, producing a knife tip speed of up to 187 mph to slice through dense, wet grasses, fire ant hills and gopher mounds. Select from four new heavy-duty models, including a new pull-type model with a cut width of over 10 feet.

HEAVY-DUTY DISC MOWER® LINEUP

107M

6′ 8″ Cutting Width – 5 Discs
3-Point Mounted – Cat. I or II
Min. 45 PTO HP

108M

7′ 10″ Cutting Width – 6 Discs
3-Point Mounted – Cat. II
Min. 55 PTO HP

109M

9′ 2″ Cutting Width – 7 Discs
3-Point Mounted – Cat. II
Min. 60 PTO HP

210M

10′ 4″ Cutting Width – 8 Discs
Pull-Type
Min. 60 PTO HP

A CUT ABOVE THE REST

All four heavy-duty disc mower models feature the latest advance in New Holland true modular cutterbar technology—the MowMax cutterbar equipped with the ShockPRO™ cutterbar protection system. This is the same design used on larger Discbine® disc mower-conditioners so you are assured of maximum durability and peace of mind. Each disc module is an individually sealed gear case with a dedicated oil reservoir. Even when cutting on slopes, there’s never an oil starvation issue. The gears stay fully lubricated and work reliably. If an internal component ever fails, there’s no chance that a broken piece can circulate in the oil bath and damage other modules. And, each gear case is connected with independent, hard- ened alloy drive shafts, not a single-piece drive shaft that can twist or shear. When routine maintenance is required, it’s fast and inexpensive.

AUTOMATIC REACTION TO FIELD CHANGES

A flotation spring on H6700 mounted mowers allows for vertical cutterbar movement over field obstructions. In addition, a spring-loaded breakaway latch allows the cutterbar to swing back if it hits an immovable object in the field.

EASY SERVICE AND ADJUSTMENT

Two cutting edges on each knife provide twice the cutting life. You can flip or replace knives easily from the front of the cutterbar. Each knife is retained with only one bolt, and there’s no need to raise the cutterbar or reach from the back of the cutterbar to access the knife bolts. Mounted disc mowers feature an exclusive V-belt tension spring with an easy-to-see tension indicator so you can check belt tension at a glance. Adjusting tension is easy too. There are no shields to remove. All it takes is a turn of a nut. Left- and right-hand swathboards are available to allow for swath width adjustment.

ADDITIONAL MOWMAX™ FEATURES

Lower-profile rock guards allow for closer cutting at a flatter cutting angle
Stepped module spacers improve the straight- ness of the cutterbar, allowing it to run more lightly and smoothly for consistent cut height and less wear.
The fit of the top cap bearing to the housing is optimized to extend bearing life.
More gentle bends in the knife bolt area of the “turtle” reduce wear concentration.
Hardened alloy module drive shafts with dampeners eliminate vibration wear.
Stronger top cap gear and the ShockPRO hub design eliminates the need to change top cap gear assemblies if there is impact from a foreign object. A partial complement of splines allows the hub to fail instead of the gears

The ShockPRO™ Advantage

Replaceable ShockPRO hubs protect the entire cutterbar driveline to minimize downtime and repair costs if the machine encounters a field obstruction. Economical ShockPRO hubs absorb the shock of the impact before damage can occur to expensive drive components. If necessary, these hubs can be replaced in the field in under ten minutes, at minimal cost.